WETSUIT REPAIR GLUE - NEOPRENE SEALANT

Products

WETSUIT REPAIR GLUE - NEOPRENE SEALANT

  • Details

WETSUIT REPAIR GLUE - NEOPRENE SEALANT

NEOPRENE REPAIK KIT

THE NEOPRENE REPAIR KIT SUPERB FOR THOSE ON THE SPOT NEOPRENE REPAIR KIT. SUPPLIED WITH QUICK DYRING NEOPRENE ADHESIVE ESPECIALLY FOURMULATED FOR USE ON NEOPRENE TO REPAIR PUNCTURES,NICKS, CUTS.

GLUE REPAIR KIT CONTAINS:
1X 10ML TUBE OF NEOPRENE GLUE
1X 1’’ NEOPRENE DISKS
1X2’’ NEOPRENE DISKS
2X3’’ NEOPRENE DISKS


KIT INSTRUCTIONS:

1.    Locate the hole/rip or tear in the neoprene, clean the surrounding area with fresh water and leave to dry.
2.    If the damage is small you should be able to repair the split/hole using the neoprene adhesive.Stretch open the hole and apply glue to the either side. Allow the glue to become tacky wait a couple of minutes before pinching the hole closed using a bulldog clip. This should be left for a minumum of 1 hour. Please allow 24 hours for the glue to dry completely.
3.    For bigger holes/tears follow steps above then turn your neoprene wetsuit/accessories inside out to expose the damaged area.
4.    Take on of the neoprene reapaik disks or tape supplied picking the correct size.Draw a circle around the disk so that the tear/hole is in the middle.
5.    Apply a coating of glue to the neoprene disk and onto the makred circle on the inside of the neoprene this to dry for 5-6 hours before applying a second coat to both.Allow this coat to dry for 2~3 minutes and then apply the patch and push the two layers firmly together.
6.    Place your neoprend wetsuit/accesorries on a flat surface with a heavy wieghted object over the patch.You should leave this for 24 hours.
7.    Your hole/tear should be fixed and your garment/accessory raedy to wear.


REPAIR WITHOUT PATCH/ NEOPRENE DISKS 

Clean the damaged area. Apply a thin layer of
Neoprene adhesive to both the edges of the ripped neoprene.It should become
touch dry in three minutes. Apply a second thin layer of adhesive again. Wait for it to
become touch dry again. Then carefully align the edges and press them firrmly together.
Hold for a further two minutes under pressure.
The repair is now finished and ready for use. The bond achieves full strength after 24
hours but wetsuit can be used with care immediately.

Next Product:Black Neoprene Cement Wetsuit Flexible Waterproof Repair Seal Cement Kit

Post your feedback

The Code: